Light Signals

Causes

Solution

Machine at correct temperature for coffee bean dispensing and for hot water dispensing Proceed with the dispensing process
Machine at correct temperature for ground coffee dispensing (pre-ground) Proceed with the dispensing process
Machine dispensing steam Proceed with steam dispensing
  Machine dispensing hot water Proceed with hot water dispensing
Machine dispensing a coffee Wait for the dispensing process to end (dispensing stops when you press the key again)
Machine dispensing two coffees Wait for the dispensing process to end (dispensing stops when you press the key again)
The machine is being programmed with the coffee cup fill level Stop dispensing as desired
Machine in pre-heating phase for coffee, hot water and steam dispensing Wait until heated (see bar)
Machine in rinsing phase Wait until end of procedure
The appliance requires a descaling cycle Perform the descaling cycle. To enter the descaling cycle press the aroma/pre-ground coffee key for 5 sec.
No coffee beans inside hopper After filling the coffee bean hopper, start the cycle again
No water Fill the water tank
Service door open: Close it If the service door is opened while product is being dispensed, the appliance stops dispensing and starts a 30 sec. countdown before cancelling the dispensing process. The countdown can be stopped by closing the service door and operation will resume from its stopping point.
Turn the hot water/steam valve knob to the correct position. If the knob is turned (open) while product is being dispensed, the appliance stops dispensing and starts a 30 sec. countdown before cancelling the dispensing process. The countdown can be stopped by closing the knob and operation will resume from its stopping point.
No brew group If the brew group is removed while product is being dispensed, the appliance stops dispensing and starts a 30 sec. countdown before cancelling the dispensing process. The countdown can be stopped by re-inserting the brew group and closing the service door; operation will resume from its stopping point.
Refill circuit Turn the knob to the cup (icon)
Empty the dreg drawer To reset the dreg counter, wait for the icon to flash (5 sec.)
Insert dreg drawer When the dreg counter is reset, the icon flashes